• Solar charge controller

The MPPT VE.Can SmartSolar charger uses the latest and fastest technology to convert energy from a solar array into energy that optimally charges a battery bank.

The SmartSolar charge controller will even recharge a severely depleted battery. It can operate with a battery voltage as low as 0 Volts, provided the cells are not permanently sulphated or otherwise damaged.

• MPPT: Ultra Fast Maximum Power Point Tracking

The MPPT VE.Can SmartSolar charger connects to a PV array of 150 or 250 Volt Voc and will automatically detect and charge your 12, 24, or 48V battery bank with current ranging from 70 to 100A depending on the model.

The charge settings are fully programmable and can even be set up for different battery chemistries, like lead-acid, lithium and others.

• Control Your Charger Remotely

The MPPT VE.Can SmartSolar charger can be remotely controlled and configured over Bluetooth via the VictronConnect App. This allows device set-up, management, and at-a-glance information, such as battery voltage and current, PV voltage and current, and historical data.

• Daisy Chain Additional Units

The VE.Can SmartSolar charger is equipped with CAN bus ports. This allows for communication with additional VE.Can SmartSolar chargers. The additional units are simply “daisy-chained” to each other with a single RJ45 cable between the individual units.

When connected to each other, all individual VE.Can SmartSolar chargers, will synchronize their charge stages. They can also send their data, via a single cable, to a GX monitoring device.

• Remote Monitoring and Control

If the GX device is connected to the internet, the Victron Remote Management Portal (VRM) provides access to the full power of your solar charger(s).

For remote installations – even when there is no internet connection nearby – you may be able to monitor your MPPT by connecting the  GlobalLink 520.

• SmartSolar Control Display

The VE.Can SmartSolar charger is also equipped with a VE.Direct port like our other MPPT solar chargers. This port can be for single unit monitoring or for streetlight control. The remote on/off connector can be externally controlled by a third-party device like a lithium battery. An optional plug-in LCD display/control provides live-data, set-up and management, straight from the face of the device.

Large capacity all-in-one hybrid inverter for commercial application, supporting up to 600kW system capacity.

Features

• All-in-one hybrid inverter
  Battery, load, grid, and solar connection are all supported.
• Programmable working mode
  Peak-shaving, back-up, use the system however you want it.
•  Scalable design
  Quadruple capacity by paralleling 4 units.
• Hot back-up 

  One inverter fails in a parallel system, the other(s) takes over seamlessly.

• Touchscreen LCD
  More convenient for parameter setting and maintenance.
• Seamless transfer
  Uninterruptable power supply guaranteed.
• Dry contact output
  Supports remote control of DG.

27″ QHD (2560 x 1440) Adjustable stand; VESA mountable; Sustainable. 1 HDMI 2.0; 1 DisplayPort™ 1.4-in; 1 DisplayPort™ 1.4-out; 1 USB Type B (upstream); 4 SuperSpeed USB Type-A 5Gbps signaling rate (2 with Battery charging 1.2)

HP 240 G10 core i3-1315U 14 inch HD / 8GB 1D DDR4 3200 / 512GB PCIe NVMe Value / DOS3.0 / Flint Opaque keyboard (968K8ET)